JBL ARC SUB10 Service Manual page 5

Amplifier/Subwoofer
Limiter
THD at Max. Output
n/a
Power
Features
V o l u m e p o t T a p e r
(lin/log)
HP Speaker out
Input Configuration
Line In & LFE
Spkr/Hi Level In
Signal Sensing (ATO)
Auto-Turn-On
ATO Input test frequency
ATO Line level in
ATO Level Speaker in
ATO Turn-on time
Auto Mute/ Turn-OFF
Time
Power on Delay time
Transients/Pops
ATO Transient
Turn-on Transient
Turn-off Transient
Efficiency
Efficiency
Stand-by Input Power
Power Cons. @ rated
power
Protection
Short Circuit Protection
Thermal Protection
Line Fuse Rating
US (120v) version
EU
n/a functional
—
LOG
— functional
functional
YES — functional
YES — functional
YES functional
40 Hz functional
5 mV functional
50 mV functional
5
ms functional
15 17
minutes
0.1 sec. 5
5 mV-peak 50
2 Vpk-pk 2
2 Vpk-pk 2
65 % 64
15 18
Watts
76 80
Watts
YES
functional
YES
functional
Amps 0.6
Amps TBD
Maximum Output Power
Auto - on selection switch in Auto
"
"
"
T before muting, after signal is removed Auto turn of time (T) must be 3 > T < 15
AC Power Applied
@ Speaker Outputs
@ Speaker Outputs
@ nom. line voltage
@ nom. line voltage
Direct short at output
@1/8 max unclipped Power IEC Noise
using driver load
Type-T or Slo Blo-250 V
Type-T or Slo Blo-250 V
ARC SUB10/DS-10
Maximum THD as a result of limiting.
Refer to filter section
LR dual RCA jack
Spring type connector
Bicolor LED (Green=signal/ red= No signal)
Amp connected and AC on, then input signal
applied
Minutes
AC Line cycled from OFF to ON
AC Line cycled from ON to OFF
Nominal Line voltage 120 VAC / 230 VAC
Auto turn of time (T) must be 3 > T < 15
Minutes
75 Watts @ 4 Ohms nominal line voltage
Amplifier should resume operation after short
circuit condition removal
Temperature rise in accessible metal parts
should not exceed 35K rise for 120v version
or 30K rise for European versions (refer to
requirements sheet).
Internal fuse
External fuse with UL/SEMKO rated holder
5