The Master Tune Section; The Arpeggiator ("Arpeggio") - Arturia JUP-8V User Manual

4.1.10 The Master Tune section

Among these parameters you will find: the general tuning of the Jup-8 V, the
detune option for the voices and a 440 Hz tone to tune the Jup-8 V.
 TUNE: Knob to set the general tuning of the synthesizer (+/- one
semitone).
 DETUNE: Set the amount of detune of the polyphonic voices.
The detune knob of the polyphonic voices is very useful to make out-of-tune
sounds in the "unison" mode. It will sound a little like the effect of a chorus.
When the «Unison» is not active, this parameter brings a little more instability to
the tuning of the oscillators, a typical characteristic of the original machine.

4.1.11 The arpeggiator ("ARPEGGIO")

This section shows the connections that are necessary to make the arpeggiator
work. It allows performance of patterns of notes in a particular order, evolving
according to the notes played.
 In SPLIT mode, the arpeggiator only works with the lower part of the
keyboard.
 In DUAL MODE, the arpeggiator works on both parts of the keyboard.
The pattern development is possible to control with two parameters:
 RANGE: Choose the range of the arpeggiator 1-4(in octaves):
o One octave (button ON/OFF "1")
o Two octaves (button ON/OFF "2")
o Three octaves (button ON/OFF "3")
o Four octaves (button ON/OFF "4")
 MODE: Choose the playing mode:
o UP (button ON/OFF)
o Down (button ON/OFF)
o Up and Down (button ON/OFF)
o Random (button ON/OFF)
The rate of the arpeggiator can be set on the left side of the LFO section (next
to the general volume and LOWER / UPPER balance potentiometers).
In the same area, you can also affect the MIDI synchronization for the
arpeggiator rate ("EXT" position).
ARTURIA – Jup-8 V – USER MANUAL
The Master Tune parameters
50