Motor Protection Filter - Philips Marathon FC9219 - FC9200 User Manual

1 Switch off the appliance and remove the hose.
2 Press the release button on top of the dust bucket handle to unlock the cover (1). Swing
open the cover (2) (Fig. 19).
 Lift the dust bucket out of the appliance (Fig. 20).
 Lift the filter cylinder case out of the bucket (Fig. 21).
5 Turn the handle on top of the filter cylinder case anticlockwise (1) and lift the filter cylinder
out of the case (2). (Fig. 22)
6 Clean the filter cylinder and the case with the brush supplied. Brush from the top of the filter
downwards along the ribs of the filter (Fig. 23).
Only use the brush supplied. Other brushes may damage the filter cylinder.
7 If there is dirt on the inside of the case, empty the case over a dustbin.
8 If you wish, you can clean the filter cylinder case with cold tap water and some washing-up
liquid.
9 If you want to wash the filter cylinder, wash it thoroughly with only water. Do not use any
soap, washing-up liquid or other detergent to clean the filter. Let the filter cylinder dry
completely before you reinsert it into the case (Fig. 24).
10 Put the filter cylinder back into the case and turn the handle clockwise until the filter
cylinder locks into position.
Make sure the filter cylinder is securely fixed in the case.
11 Put the case with the filter cylinder back into the dust bucket.

Motor protection filter

Clean the permanent motor protection filter every time you clean the filter cylinder case.
1 Take the motor protection filter out of the appliance. Clean the filter by tapping the dust out
of it over a dustbin (Fig. 25).
If the motor protection filter is very dirty, you can also rinse it with cold tap water.
Do not use washing-up liquid or any other cleaning agent to clean the motor protection filter.
2 Press the clean filter firmly back into the filter compartment to ensure that it is properly
placed.
super Clean air filter, super Clean air HePa 12 filter or ultra Clean air HePa
13 filter
This appliance is equipped with either the Super Clean Air filter, the Super Clean Air HEPA 12 filter
or the Ultra Clean Air HEPA 13 filter. These filters are located in the back of the appliance.
Note: To guarantee optimal dust retention and performance of the vacuum cleaner, always replace
the filter with an original Philips filter of the correct type (see chapter 'Ordering accessories').
super Clean air filter
The Super Clean Air filter filters a large part of the smaller particles from the exhaust air with its
electrostatically charged fibres.
Replace the Super Clean Air filter every six months. This filter is not washable.
1 Remove the filter grille (Fig. 26).
2 Remove the old filter (Fig. 27).
 Insert the new filter into the appliance.
4222.003.3090.4.indd 9
English
9
22-11-2007 10:20:07