Disassembling/ Assembling Of Job Light Section - Makita BFL301F Technical Information

R
epair
[3] DISASSEMBLING/ ASSEMBLING

[3] -1. Disassembling/ Assembling of Job Light Section

DISASSEMBLING
(1) Remove Lead cover by removing Ring spring 36, and Ring spring 29 with a slotted screwdriver. (Figs. 2, 3 and 4)
(2) Remove Light covers (R) and (L) while pushing the portion designated by the gray circle to unlock the tab on
Light cover (R) from the slot of Light cover (L). (Fig. 5)
(3) Separate Switch cover from the tool by removing two M4x8 Pan head screws.
(4) Remove Lead wires and LED circuit from Lead wire holders and Light cover (R), and disconnect Connector. (Fig. 6)
Fig. 2
Light cover (L) M4x8 Pan head screw (for fixing Ring 38)
Ring spring 29
Light cover (R)
Fig. 3
Push the end face of Lead cover using a slotted
screwdriver till it is lifted up and remove Lead cover
by pulling it to the described direction below.
ASSEMBLING
(1) Fix Lead wires securely in Lead wire holders and then install LED circuit on Light cover (R).
At this time, make a slack of Lead wires in place as the right illustration in Fig. 6.
(2) Push the tab on Switch cover into the cut in Housing before fastening screws. And then fix Switch cover with two
M4x8 Pan head screws. Do not pinch the Lead wires in this step. (Figs. 2, 7)
(3) Install Light covers (R) and (L) while locking the tab on Light cover (R) in the slot in (L), then Ring spring 29. (Fig. 5)
Ring spring 29 can be easily installed by fixing one end on the groove in Light cover, then pushing toward Light cover
while expanding the other end. (Fig. 8)
(4) Fix Lead cover and Ring spring 36 carefully so as not to pinch the Lead wires from LED circuit. (Fig. 9)
Fig. 6
LED circuit Lead wire holders
Fig. 8
Ring spring 29
Ring spring 36
Lead cover Switch cover
Fig. 4
Make a slack of Lead wires
in this portion.
Fig. 9
Pan head screw M4x8
(for fixing Switch cover)
Fig. 5
Ring spring 29 Push here.
Fig. 7
Switch cover
Lead cover
Ring spring 36
Lead wire
P 4/ 14
tab
tab