Tire Sealing System - Checking Inflation Pressure; Tire Sealing System* - Inflating Tires - Volvo S80 Owner's Manual

WARNING
If heavy vibrations, unsteady steering
behavior, or noises should occur while
driving, reduce speed and park the vehicle
in a safe place. Recheck the tire for
bumps, cracks, or other visible damage,
and recheck its inflation pressure. If the
pressure is below 19 psi (1.3 bar), do not
continue driving. Have the vehicle towed
to a trained and qualified Volvo service
technician.
Tire sealing system – checking
inflation pressure
The tire sealing system can also be used to
check the tires' inflation pressure.
Stage 2: Checking inflation pressure
1. Reconnect the tire sealing system's hose
to the tire's inflation valve as described in
stage 1, see Tire sealing system* – seal-
ing a hole (p. 301).
2. Refer to the inflation pressure table in this
chapter for the correct inflation pressure.
If the tire needs to be inflated, start the
tire sealing system's compressor. If nec-
essary, release air from the tire by turning
the air release knob counterclockwise.
CAUTION
The compressor should not be used for
more than 10 minutes at a time to avoid
overheating.
WARNING
If you interrupt your trip for more than 1
hour, check the inflation pressure in the
damaged tire again before continuing.
09 Wheels and tires
Tire sealing system* – inflating tires
The tire sealing system can be used to inflate
the tires.
To do so:
1. Park the car in a safe place.
2. The compressor should be switched off.
Ensure that the on/off switch is in position
0 (the 0 side of the switch should be
pressed down).
3. Take out the electrical wire and hose.
4. Remove the valve cap from the tire's
inflation valve and screw the hose con-
nector onto the valve as tightly as possi-
ble by hand.
5. Connect the electrical wire to the nearest
12-volt socket in the vehicle.
6. Start the vehicle's engine.
*
Option/accessory, for more information, see Introduction.
09
}}
303