Trip Computer - Supplementary Information - Volvo S80 Owner's Manual

Trip computer – Supplementary
information
General information for both Analog and Digi-
tal trip computer functions.
Average fuel consumption
Fuel consumption since the last time this
function was reset.
Average speed
The vehicle's average speed since the last
time this function was reset.
Current fuel consumption
Current fuel consumption is calculated
approximately once a second. When the vehi-
cle is moving at low speed, fuel consumption
is displayed per unit of time. At higher
speeds, it is displayed in terms of distance.
Miles or kilometers can be displayed, see the
heading "Changing units".
Distance to empty
This function shows the approximate dis-
tance that can be driven on the fuel remaining
Distance to empty
in the tank. When
"----", there is very little useable fuel remain-
ing in that tank; refuel as soon as possible.
The calculation is based on average fuel con-
sumption during the last 20 miles (30 km) of
driving and the amount of fuel remaining in
the tank (the accuracy of this figure may vary
if your driving style changes). An economical
driving style will generally increase this dis-
tance.
See Economical driving (p. 266) for informa-
tion about driving economically.
Digital speed display*
Speed is expressed in the unit not used by
the instrument panel's speedometer e.g., if
the normal speedometer is in mph, the trip
computer will display in the speed in km/h
and vice versa.
Resetting an analog instrument panel
Trip odometer(s) and average speed
1. Display trip odometer T1 or T1, or Aver-
age speed.
2. Press and hold RESET until selected
function is reset.
Each trip computer heading must be reset
individually.
Resetting a digital instrument panel
Trip odometer
1. Turn the thumb wheel to select the com-
shows
bination of headings containing the trip
odometer to be reset.
2. Press and hold RESET until selected trip
odometer is reset.
Average speed and fuel consumption
Trip computer reset
1. Select
OK.
03 Instruments and controls
2. Select one of the following alternatives
using the thumb wheel and press OK:
•
mpg
•
mph
•
Reset both
3. Finish by pressing RESET.
Changing units
To change the unit (miles/km) used to meas-
ure distance and speed, go to
Settings System options
and fuel units.
NOTE
In addition to changing units in the trip
computer, this also changes the units used
in the Volvo Navigation System (VNS)*.
Related information
•
Trip computer – introduction (p. 109)
•
Trip computer – functions, analog instru-
ment panel (p. 110)
•
Trip computer – functions, digital instru-
ment panel (p. 113)
•
Trip computer – Trip statistics (p. 116)
and press
*
Option/accessory, for more information, see Introduction.
03
MY CAR
Distance
115