MEDIA FUNK XT 700 Operating Instructions Manual page 29

4.3 Channel selection
The mediaFunk ® systems has 4 different transmitting channels. You can change the transmission channel
with the channel selection switches on the bottom of the transmitter/receiver. The numbers indicate the
selected channel. This function permits the installation of various Media Funk systems at home without
disturbing each other.
Attention: It must be set the same channel on both transmitter and receiver!
The channel selection interests only the A/V transmitting/receiving RF-sections.
4.4 Receiver for the IR remote control
The receiver of the mediaFunk ® system integrates one receiver for IR remote control (behind the black
window). It converts the infrared (IR) signal emitted by your remote control to a radio frequency (RF) signal
in UHF band at the receiver and sends it back to the transmitter where the RF signal is converted back to
the original IR signal and beamed to the audio/video source.
4.5 Transmitter for the IR remote control
The transmitter of the mediaFunk ® system can receive and retransmitt the IR signals of the original remote
control. It also gives you the ability to control the source (SAT receiver, videorecorder, DVD ecc.) using your
existing remote control device.
Simply connect the IR extender (5) into the jack of transmitter's upper side and locate this near the source.
Orient the end of the IR extender so that it points in the general direction of the IR sensors of the A/V equip-
ment you wish to be controlled.
SAT Receiver
Infrared receiver
Infrared transmitter
29