Setting The Clock - AEG MRC 4121 Instruction Manual

NOTE:
To execute the function, the distance between your hand and the sensors should be
max. 10 cm.
Turn the beep off/on when using the infrared sensors
A beep sounds when you pass your hand over the infrared sensors. If you want to turn off
the beep, proceed as follows:
1. Switch the device to standby using the
2. Keep the /SENSOR BEEP button (10) pressed until "
display.
Turn the beep on again: To switch the beep on again, keep the
pressed again. " " briefly appears on the display.
Restore Factory Defaults
Any malfunctions during operation can be rectified by pressing the Reset button.
• Push the (13) button with the help of a wire or a similar item to reset the electronics.

Setting the Clock

1. Use the button (9) to switch the device to standby.
2. Hold the CLK.ADJ / TEMP button (5) depressed until the year indication on the display
flashes.
• Now you can set the year, the month, the day, the time display format (12Hr/24Hr),
the hours, and the minutes with the buttons / DST/C-F (7) and / Y-M-D (6).
• In each case, confirm the input with the CLK.ADJ / TEMP button. The current
indication to be set flashes on the display.
NOTE:
• The input is stored automatically within approximately 30 seconds when no button is
pressed.
• If the time is displayed in 12 hour format, the point next to PM lights up (18):
PM = Afternoon
• Setting of the weekday is done automatically. For technical reasons, the weekday
cannot be shown on the display.
button (9).
" is shown briefly on the
/SENSOR BEEP button
English
71