Technical Data; Before Starting The Equipment - EINHELL RT-CC315 UD Operating Instructions Manual

Anleitung_RT_CC_315_UD_SPK1:_
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

AC motor
Power P 1800 W S1 2200 W S6 40%
Idle speed n
0
Carbide saw blade
Number of teeth
Main table dimensions
Sliding table dimensions
Sliding length max.
Cutting height max.
Infinite height adjustment
Infinitely adjustable saw blade angle
Dust extraction connector
Weight:
Operating mode S1: Continuous operation
Operating mode S6 40%: Continuous operation
with idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 40% of the cycle at the specified
rating and must then be allowed to idle for 60% of the
cycle.
Noise emission values
Operation
L sound pressure level
pA
L sound power level
WA
29.12.2008 15:33 Uhr
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors with
a potential influence on the actual immission level at
the workplace include the duration of impact, the type
of room, and other sources of noise etc., e.g. the
number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the user
should at least be able to make a better assessment
of the dangers and risks involved.

5. Before starting the equipment

400V 3 ~ 50Hz
2750 rpm
Ø 315 x Ø 30 x 3.6 mm
24
800 x 350 mm
1000 x 300 mm
600 mm
73 mm / 0°
49 mm / 45°
0 - 73 mm
0° - 45°
Ø 100 mm
52 kg
5.1 Assembly
Important. Pull out the power plug before
carrying out any maintenance, resetting or
Idle speed assembly work on the cutting-off machine!
90.6 dB 78.1 dB
105.1 dB 92.5 dB
Seite 23
This machine may only be assembled by trained
personnel or other personnel with similar
qualifications.
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Inspect the microswitch of the sliding table
regularly to ensure it works correctly. You are
allowed to operate the saw only when the sliding
table is correctly mounted.
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws, etc.
Before you actuate the On/Off/Emergency switch
(9), make sure that the saw blade is correctly
fitted and that the machine's moving parts run
smoothly.
Check the supplied package to ensure it is
complete (see point 2.4).
GB
23