Replacing The License Plate Light Bulb; Supporting The Motorcycle - Yamaha FZ8NB Owner's Manual

Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
1. Screw
2. License plate light unit
2. Remove the license plate light bulb
socket (together with the bulb) by
pulling it out.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24313
1
1. License plate light bulb
2. License plate light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
7-37

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
2
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
EAU24350
7