Section 6 Adjustment Of Cutting Height; Section 7 Safety Precautions - AND 0503N1E-MDL04-320 Original Instructions Manual

1. To fit: Raise the rear cover and hitch the grass catcher on rear of mower. (Fig.3A/Fig.3B/Fig.3C)
2. To remove: Grasp and lift the rear cover, remove grass catcher.
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or full :
- If the catcher is full, the indicator collapses; once this happens, stop moving immediately and empty the
Fig.3A
Level indicator
IMPORTANT:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the position of
indicator opening immediately.
6. ADJUSTMENT OF CUTTING HEIGHT
Pull out the wheel shaft and put it into the groove of the operator's cutting height during gear adjustment. The
lowest height is 20mm, mid height is 40mm, the highest height is 60mm (Abb. 4A/Abb. 4B/Abb.4C)
Abb.4A
WARNING: Make this adjustment only when the blade is stopped.
WARNING: Disconnect the electric cord from the power supply.
7. SAFETY PRECAUTIONS
a) Always operate with the deflector or grass catcher in the correct position.
b) Always stop the motor before removing the grass catcher or adjusting the height of cutting position.
1. Before mowing, remove all foreign objects from the lawn which may be thrown by the machine.
-
Fig.3B
Abb.4B
Rear cover
Fig.3C
Abb.4C
- 9
Проверил: Р.Ч./24.03.2015г