AND 0503N1E-MDL04-320 Original Instructions Manual page 6

27) Keep all nuts, blots and screws tight to be sure the equipment is in safe working condition.
28) Check the grass catcher frequently for wear or deterioration.
29) Replace worn or damaged parts for safety.
30) Do not use the lawnmower if the cords are damaged or worn.
31) Do not connect a damaged cord to the supply or touch a damaged cord before it is disconnected from the
supply. A damaged cord can lead to contact with live parts.
32) Do not touch the blade before the machine is disconnected form the supply and the blade have come to a
complete stop.
33) To keep extension cords away from the blade. The blade can cause damage to the cords and lead to contact
with live parts.
34) To disconnect the supply (i.e. pulling the plug from the socket):
-whenever leaving the machine unattended;
-before clearing a blockage;
-before checking, cleaning or working on the machine;
-after striking a foreign object;
-whenever the machine starts vibrating abnormally.
35) This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
36) If the external flexible cable or cord is damaged, it shall be exclusively replaced by the manufacturer or his
service agent or a similar qualified person in order to avoid a hazard (not light than H05VV-F 2x1.0mm
37）Instructions for the safe operation of the appliance, including a recommendation that the appliance should be
supplied via a Residual Current Device (RCD) with a tripping current of not more than 30 Ma.
38) Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and
fixed parts of the machine.
39) Always allow the machine to cool before storing.
40) When servicing the blades be aware that, even though the power source is switched off, the blades can still be
moved.
41) Replace worn or damaged parts for safety; Use only genuine replacement parts and accessories.
42) Be careful during adjustment of the appliance to prevent entrapment of the fingers between moving blades
and fixed parts of appliance.
43) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
-
- 6
2
)
Проверил: Р.Ч./24.03.2015г