Nortel Contivity Secure IP Services Gateway 4600 Owner's Manual page 6

The physical interfaces include a power plug, power and reset switches, a serial port, a
LAN Port RJ-45 connector and up to two additional network connectors. Each RJ-45
connector is accompanied by light emitting diodes (LEDs). The LAN Port LEDs, with
the green LED indicating 100Mbps activity and the orange LED indicating link status and
activity, are located on the back panel of the module. More information on the LEDs and
the LAN Port interface can be found in Getting Started with the Contivity Extranet Switch
4600.
The physical interfaces, the LAN port, the 10/100Base-TX ports, serials port and status
LEDs, map to the logical interfaces defined in FIPS 140-1 as described in Table 1.
Switch physical interface
10/100BASE-TX LAN Ports,
LAN Port
10/100BASE-TX LAN Ports,
LAN Port
Power Switch,
Reset Switch,
Serial Port,
LAN Port
LAN Port LEDs,
10/100BASE-TX LAN Port LEDs
Serial Port
Power Plug
Figure 2 – Physical Interfaces
FIPS 140-1 Logical Interface
Data Input Interface
Data Output Interface
Control Input Interface
Status Output Interface
Power Interface
Table 1 – FIPS 140-1 Logical Interfaces
6