Nikon Coolpix L110 User Manual page 141

Problem
Monitor turns off, and the
power-on lamp blinks rapidly.
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not saved
to internal memory or the memory card at the time the problem occurred. Data
already saved will not be affected.
Shooting
Problem
No picture taken when shutter-
release button is pressed.
Cannot use shooting mode.
Camera cannot focus.
Images are blurred.
Comet-like streaks that whiten
toward either end appear in the
monitor.
Cause/Solution
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamps blink for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
Cause/Solution
• When camera is in playback mode, press A.
• When menus are displayed, press d.
• Battery exhausted.
• When flash lamp blinks, flash is charging.
Disconnect the HDMI cable or USB cable.
• The intended subject is one with which
autofocus does not perform well.
• Set AF assist in the setup menu to Auto.
• Focus error. Turn camera off and then on
again.
• Use flash.
• Raise the ISO sensitivity.
• Use vibration reduction and motion detection.
• Use D (Best Shot Selector).
• Use tripod and self-timer.
Smear may occur when the camera is aimed at a
bright subject. When using multi-16, sport
continuous, or when recording movies, avoid
bright objects such as the sun, reflections of the
sun, and electric lights.
Troubleshooting
A
14
A
10
12
20
30
80, 83,
88
25
106
20
29
56
104, 105
55
5, 32
55, 121
129