Adjusting The Tv Receiver To The Video Channel - Sanyo VHR-510 Instruction Manual

VCR PRESETTING
After all connections have been made, insert the
remote control batteries then proceed to
"Adjusting the TV receiver to the video channel"
+"Tuning control
adjustments" +"Clock
setting" to preset the VCR.
Before starting
Press the POWER button.
Turn on the TV.
POWER
CLMKPRESET
00
O&n
oeJ&l
cin15&
05500
Adjusting the
TV
receiver to the video
channel -
If the VCR has been connected to the TV using the
"AV connection", simply set the TV to the AV mode.
You can skip this step.
When using the "RF connection", follow the steps
below,
O Set your TV receiver to "VCR", "AV" or to the
position designated for videorecorder use
(usually a position where no TV programme is
received),
For more details, please refer to your TV receiver
instruction manual.
@ Adjust the tuning on the TV to UHFchannel 36
(37 - 38) so that the test pattern (2 vertical bars)
is clear.
This Is your video channel.
II Whenever you play back a tape or watch a TV
programme tuned on the VCR tuner, set the TV to
your video channel.
~
Australia 37 – 38
33-43
III
Note:
If the clock setting and/or the tuning control
adjustments are completed before setting the video
channel, the test pattern will not appear on the TV
screen.
•1
1
2
If in your area, UHF channel 36 (37 - 38) is used
by a TV station, follow the steps below.
Tune the TV receiver to an available UHF channel
between channel 32 and 41 (33 and 43).
Using a small screwdriver, slowly turn the video
channel adjustment screw "RF CHANNEL on the
back of the VCR, to the right for a higher channel
than 36 (37 – 38) and to the left for a lower
channel than 36 (37 – 38).
Adjust the tuning on the TV, if necessary, so that
the test pattern is clear.
If the test pattern does not appear, set the video
channel using a prerecorded VHS video cassette.
1 Play back the tape.
2 Tune the TV receiver to obtain clear pictures and
sound while monitoring playback on the TV
screen.
'REPARATION
7
— —- --