Specifications - Makita LS1013 Instruction Manual

SPECIFICATIONS

Model
Blade diameter
Hole diameter
For all countries other than European countries
For European countries
Max. Cutting capacities (H x W) with 260 mm in diameter
-1
No load speed (min )
Laser Type (LS1013L/LS1013FL only)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･
Always remove SUB-FENCE R when
performing right bevel cuts. Failure to
do so may cause serious injury to
operator.
Miter angle
0°
45°
52° (right)
45° (left)
50 mm x 310 mm
(left) 50 mm x 200 mm
(right) 50 mm x 220 mm
-
LS1013/LS1013F.......715 mm x 520 mm x 625 mm
LS1013L/LS1013FL .......715 mm x 520 mm x 640 mm
LS1013: 22.4 kg, LS1013F: 22.6 kg, LS1013L: 23.2 kg, LS1013FL: 23.4 kg
END216-3
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
8
LS1013 /LS1013F/ LS1013L/LS1013FL
Bevel angle
0°
91 mm x 310 mm
91 mm x 220 mm
91 mm x 190 mm
Red Laser 650 nm,
･
Never look into the laser beam. Direct
laser beam may injure your eyes.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
250 mm - 260 mm
25 mm and 25.4 mm
30 mm
45° (right)
31 mm x 310 mm
31 mm x 220 mm
-
3,700
1mW ( Laser Class 2 )
/II
and its
compatible
ENE006-1
ENF002-1