Measuring Blood Pressure - Sanitas SBC 27 Instructions For Use Manual

Proceed as follows to set the date and time:
• Switch on the blood pressure monitor with the
• Press the function key
• The month starts flashing. Using the "+" function key, set
the month 1 to 12 and confirm with the function key
• Set the day, hour and minute and confirm in each case
with the function key
• Confirm your selection with the function key "+".

5. Measuring blood pressure

Positioning cuff
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wrist but should
not constrict it.
for over 5 seconds.
.
Correct posture
button.
• Rest for approx. 5 minutes before each measurement. Oth-
erwise there may be divergences.
• You can perform the measurement
.
either sitting or lying down. It is
essential to support your arm and have
it at an angle. Always make sure that
the cuff is level with your heart.
Otherwise there may be serious
divergences. Relax your arm and the palms of your hands.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Select memory
Switch on the blood pressure monitor with the
Select the required memory space by pressing the function
key "+". You have two memories (60 memory spaces each) in
order to save the test results of 2 different people separately,
or else save measurements in the morning and evening
separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
• Using the buttons
the measurement process by pressing button
checking the display with all digits lighting up, the moni-
tor will automatically inflate. Following the self-test, during
which all display elements briefly appear, the measure-
ment begins. During inflation the device already determines
measured values used to estimate the required inflation
5
• • • • • • • • • • • • •
, select the user memory 1 or 2. Start
button.
. After