Transmitter Operating Instructions - AEE Toruk AP10 Manual

aee.com

4.4 Transmitter Operating Instructions

Joystick back to center /neutral: Throttle Joystick of the transmitter is set at the center position.
Joystick deviation Distance: The Distance the transmitter Joystick deviates from the Joystick center position.
Transmitter(U.S. Mode)
● In GPS mode, when all Joysticks are in the neutral position, the Quadcopter hovers at a fixed-point.
● In Normal mode, when all Joysticks are in the neutral position, the Quadcopter remains level, but may drift in a horizontal direction.
Quadcopter direction
Position-1 Position-2
Position-1 Position-2
12
The Left Joystick controls Quadcopter elevation.
Push the Joystick up, the Quadcopter rises. Pull the
Joystick down and the Quadcopter descends. Keep
the Joystick at the center position, and the Quadcopter
hovers at that particular height. Push the Left
Joystick upwards over the centered position to make
Quadcopter take off from the ground. (Please push the
Left Joystick slowly to prevent the Quadcopter from
suddenly and unexpectedly rising).
The Left Joystick also controls the Quadcopter
rudder. Push the Joystick left and the Quadcopter
rotates counterclockwise. Push the Joystick right, and
the Quadcopter rotates clockwise. If the Joystick is
centered, the Quadcopter flies in the same direction
without rotating.
The Joystick controls the rotating angular velocity
of the Quadcopter. Move the Joystick to increase
Quadcopter rotation velocity.
The Right Joystick controls the Quadcopter's front &
back tilt. Push the Joystick up and the Quadcopter
will tilt and fly forward. Pull the Joystick down and the
Quadcopter will tilt and fly backward. The Quadcopter
will keep level and straight if the Joystick is centered.
Move the Joystick faster to increase the tilt angle
(maximum is 35 degrees), and faster flight velocity.
The Right Joystick also controls the Quadcopter left
& right tilt. Push the Joystick left and the Quadcopter
will tilt and fly left. Push the Joystick right and the
Quadcopter will tilt and fly right. The Quadcopter will
keep level and straight if the Joystick is centered Move
the Joystick faster to increase the tilt angle (maximum
is 35 degrees), and faster flight velocity.
S2 is used to calibrate the left and right joysticks.
Toggle S2 to the position 3, and turn on the the
transmitter. Then move both joysticks clockwise
and counterclockwise twice, ensuring each rotation
reaches the maximum degrees. Afterwards, release
the joysticks and toggle S2 to the position 1. The video
Position-3
recording indicator (green) will light up for 3 seconds to
indicate the completion of the calibration.
S4 switch is the flight mode toggle switch.
Position 1 (GPS) is GPS mode, Position 2 (NRM) is
Normal mode, Position 3 (NULL) is Reserved function.
Position-3
Control Method