Replacement Of Door Assembly - Samsung CM1219 Service Manual

Hide thumbs Also See for CM1219:
Table of Contents

Advertisement

Disassembly and Reassembly

4-3 Replacement of Door Assembly

4-3-1 Removal of Door Assembly
NOTE: Be sure to wear gloves when you
disassemble or assemble the parts.
1. Remove hex bolts securing the upper hinge
and lower hinge. Then remove the door
assembly.
2. Insert the flat screwdriver or thin metal plate
into the gap between the door E and door C to
remove Door C from the door assembly.
3. Remove 2 screws securing the Door Handle.
4. Unbend the 6 metal tabs around the trim of
Decoration Door Cover.
5. Remove 3 screws securing the Door E Ass'y.
6. Remove upper hinge and lower hinge.
7. Remove Decoration Door, Screen B, Key-Door,
Spring-Key, Pin-Key as needed.
Decoration Door Cover
Door Handle Cover
4-3-3 Reassembly Test
After replacement of the defective component parts of the door, reassemble it and follow the
instructions below for proper installation and adjustment so as to prevent an excessive microwave
leakage.
1. When mounting the door to the oven, be sure to adjust the door parallel to the bottom line of the oven face
plate by moving the upper hinge and lower hinge in the direction necessary for proper alignment.
2. Adjust so that the door has no play between the inner door surface and oven front surface. If the door
assembly is not mounted properly, microwave energy may leak from the space between the door and oven.
3. Do the microwave leakage test.
14
4-3-2 Removal of Door Handle
1. Remove hex bolts securing the upper hinge
2. Insert the flat screwdriver or thin metal plate
NOTE: Be careful when handling Door C as is
NOTE: The thickness of the flat screwdriver or
3. Remove 2 screws securing the Door Handle to
4. Unbend the 2 metal tabs at both ends of the
Upper Hinge
Door E Ass'y
Decoration Door
Screen B
Door Handle
and lower hinge. Then remove the door
assembly.
into the gap between the door E and door C to
remove Door C from the door assembly.
fragile.
thin metal plate inserted into the gap
should be 0.5mm or less.
the Door E Ass'y.
Door Handle to remove the Door Handle Cover
from the Door Handle.
Door C
2 screws securing
Door Handle
Key-Door
Lower Hinge
Pin-Key
Spring-Key
Samsung Electronics

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cm1229

Table of Contents