Craftsman 917.20390 Operator's Manual page 25

OPERACIÓN
Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto.
Aprenda y comprenda sus significados.
MARCHA NEUTRO ALTO BAJO
ATRÁS
MOTOR MOTOR MOTOR EL CIERRE
APAGADO EN MARCHA ENCENDIDO DIFERENCIAL
SISTEMA MARCHA MARCHA PALANCA DE
FUNCIONAMIENTO ATRÁS HACIA MANDO CRUCERO
ATRÁS (ROS) ADELANTE
ACCESORIO ACCESORIO PELIGRO, GUARDE
DEL EMBRAGUE DEL EMBRAGUE LAS MANOS Y
ENGANCHADO DESENGANCHADO LOS PIES LEJOS
RUEDA LIBRE
(Solamente para los
modelos automatico)
No seguir las siguientes
instrucciones puede provocar
heridas o muerte. Los símbolos
de aviso de seguridadse utilizan
para identificar informaciones de
seguridad relativas a peligros que
pueden provocar la muerte, heridas
graves y/o daños a la máquina.
ESTRANGU- RÁPIDO LENTO INTERRUPTOR
LACIÓN
PEDAL DE FRENO DE
ALTURA
FRENO / ESTACION-
DE LA
EMBRAGUE AMIENTO
SEGADORA LA SEGADORA
LUCES COMBUS- BATERÍA
ENSENDIDAS TIBLE
15
MANTENGA EL PELIGROS DE
AREA DESPEJADA PENDIENTES
(VEA LA SECCIÓN DE LAS REGLAS DE SEGURIDAD)
PELIGRO indica un peligro que, si no se evita,
provoca muerte o lesiones graves.
ADVERTENCIA indica un peligro que, si no se evita,
puede provocar muerte o lesiones graves.
PRECAUCIÓN indica un peligro que, si no se evita,
puede provocar lesiones ligeras o moderadas.
PRECAUCIÓN cuando se utiliza sin el símbolo de
aviso, indica una situación que puede provocar
daños al tractor y/o al motor.
SUPERFICIES CALIENTES indica un peligro que,
si no se evita, puede provocar la muerte, lesiones
graves y/o danos a la máquina.
FUEGO indica un peligro que, si no se evita, puede
provocar la muerte, lesiones graves y/o danos
a la máquina.
40
TO CHECK BRAKE
If tractor requires more than five (5) feet (1,5
m) to stop at highest speed in high est gear
on a level, dry concrete or paved surface,
then brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or
paved surface, depress brake pedal all
the way down and engage parking brake.
DE IGNICIÓN
2. Disengage transmission by placing
freewheel control in "transmission dis-
engaged" position. Pull freewheel control
out and into the slot and release so it is
held in the disengaged position.
LEVANTA-
MIENTO DE
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels rotate, then the brake
needs to be serviced. Contact a Sears or
other qualified service center.
PROTECCIÓN FRONT WHEEL TOE-IN/CAM BER
DE OÍDO SE
Your new tractor front wheel toe-in and
REQUIERE
camber is set at the factory and is normal.
The front wheel toe-in and camber are not
15
adjustable. If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Replace washers and snap retaining ring
securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and pre vent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant also
pre vents tire dry rot and corrosion.
Washers
Retaining
Ring
Axle Cover
TO START ENGINE WITH A WEAK BAT-
TERY
WARNING: Lead-acid batteries gen er-
ate ex plo sive gases. Keep sparks, flame
and smoking ma te ri als away from bat ter ies.
Always wear eye pro tec tion when around
batteries.
If your battery is too weak to start the engine,
it should be recharged. (See "BATTERY" in
the MAINTENANCE section of this man u al).
If "jumper ca bles" are used for emer gen cy
starting, follow this pro ce dure:
IMPORTANT: Your tractor is equipped with
a 12 volt system. The other vehicle must also
be a 12 volt system. Do not use your tractor
battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1. Connect one end of the RED cable to the
POSITIVE (+) terminal of each battery(A-
B), taking care not to short against tractor
chassis.
2. Connect one end of the BLACK ca ble
to the NEGA TIVE (-) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and bat tery.
TO REMOVE CABLES, REVERSE ORDER
-
1. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead
Battery
Square Key (Rear
Wheel Only)
25
Fully Charged
Battery