Bosch GLI 10,8 V-LI Professional Original Instructions Manual page 15

OBJ_BUCH-1072-003.book Page 15 Thursday, July 19, 2012 10:31 AM
To remove the battery 3, press the battery unlocking button 4 and pull the battery out
of the cordless worklight toward the rear. Do not exert any force.
The battery is equipped with a NTC temperature control which allows charging only
within a temperature range of between 0 °C and 45 °C. A long battery service life is
achieved in this manner.
Observe the notes for disposal.
Operation
Starting Operation
Inserting the battery
Use only original Bosch lithium ion batteries with the voltage listed on the
nameplate of your cordless worklight. Using other batteries can lead to injuries
and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
The cordless worklight produces a light beam that emerges from the lamp
head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
When not using the cordless worklight, switch it off in order to extend the battery life.
Protection Against Deep Discharging
The lithium ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
Working Advice
Belt Clip (see figure B)
With the belt clip 5, the cordless worklight, as an example, can be hooked to a belt.
The user has both hands free and the cordless worklight is always at hand.
Bosch Power Tools
English | 15
1 609 929 W76 | (19.7.12)