Siemens TE603 series Instruction Manual page 18

en
You can specify the following settings:
Set cup size
Set up the volume dispensed for each drink
and each size of cup� The volumes set up in
the factory can be adjusted stepwise�
● Use I to choose a drink and touch
B to confirm your choice�
● Use I to choose the desired volume
and touch B to confirm your choice�
The setting is then saved�
Languages
Setting up the language to be used for
display texts�
● Use I to choose the desired
language and touch B to confirm
your choice�
Water hardness
Set this to the hardness of the local water
supply�
You can select levels 1, 2, 3 or 4� The
preset level of water hardness is level 4�
● Use I to choose the desired water
hardness and touch B to confirm
your choice�
F It is important to set the water hard-
ness correctly, so that the appliance
indicates accurately when the
descaling programme should be run�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier�
If a water softener is installed in the house,
please set the water hardness to level 3�
● Briefly dip the test strip in the water and
check the result after one minute�
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
14
1-13
14-25
26-38
39-54
Automatic shut-down
Setting how long the appliance should wait
after the last drink was prepared before it
automatically switches itself off�
You can specify values from 15 minutes to
8 hours� The factory setting is 30 minutes�
● Use I to choose the desired interval
and touch B to confirm your choice�
Coffee temperature
Specifying the temperature for coffee drinks
and hot water�
You can choose normal, high, or max�
The setting applies to all types of drink
preparation�
● Use I to choose the desired
temperature level and touch B to
confirm your choice�
Water filter
Specifying whether a water filter should be
activated or whether no filter is used.
You can choose Activate new filter or No
filter�
F Using a water filter can prevent the
build-up of limescale�
Water filters are available from retail outlets
or from customer services (see the section
"Accessories")�
Important: Before you can use a
F
new water filter it will need to be
rinsed�
● Use the measuring spoon 8 to press the
water filter firmly into the water tank 5�
● Fill the water tank with water up to the
"max" mark�
● Connect the milk tube 4c to the milk
system 4b and the suction pipe 4d�
● Insert the end of the suction pipe 4d into
the drip plate 17b�
● Touch A and use I to select
Water filter�
● Touch B and use I to select
Activate new filter�