General; Getting Started; Index To Parts And Controls - Sony SLV-SE740B Service Manual

QQ
3 7 63 1515 0

1. GENERAL

WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
Mains lead must only be changed at a qualified
service shop.
Notice for customers in the United
Kingdom and Republic of Ireland
A moulded plug complying with BS1363 is fitted to
this equipment for your safety and convenience.
Should the fuse in the plug supplied need to be
replaced, a 5 AMP fuse approved by ASTA or BSI
to BS1362, (i.e., marked with or
be used.
If the plug supplied with this equipment has a
detachable fuse cover, be sure to attach the fuse
cover after you change the fuse. Never use the plug
without the fuse cover. If you should lose the fuse
cover, please contact your nearest Sony service
station.
Precautions
Safety
• This unit operates on 220 – 240 V AC, 50 Hz.
Check that the unit's operating voltage is
identical with your local power supply.
• If anything falls into the cabinet, unplug the unit
and have it checked by qualified personnel before
operating it any further.
• The unit is not disconnected from the mains as
long as it is connected to the mains, even if the
unit itself has been turned off.
• Unplug the unit from the wall outlet if you do not
intend to use it for an extended period of time. To
disconnect the cord, pull it out by the plug, never
by the cord.
Installing
• Do not install this equipment in a confined space
such as a book or similar unit.
• Allow adequate air circulation to prevent internal
heat buildup.
• Do not place the unit on surfaces (rugs, blankets,
etc.) or near materials (curtains, draperies) that
may block the ventilation slots.
• Do not install the unit near heat sources such as
radiators or air ducts, or in a place subject to
direct sunlight, excessive dust, mechanical
vibration or shock.
• Do not install the unit in an inclined position. It is
designed to be operated in a horizontal position
TE
L 13942296513
only.
• Keep the unit and cassettes away from equipment
with strong magnets, such as microwave ovens or
large loudspeakers.
2 WARNING
For SLV-SE740G/I
A ?/1 (on/standby) switch
B Remote sensor (12)
C Tape compartment
D A (eject) button (34)
E H (play) button* (35) (53)/M
(fast-forward)/m (rewind) (35)
(53)/Playback Dial (35) (53)
F x (stop) button (21) (34) (70) (71)
www
.
http://www.xiaoyu163.com
• Do not place heavy objects on the unit.
• If the unit is brought directly from a cold to a
warm location, moisture may condense inside the
VCR and cause damage to the video head and
tape. When you first install the unit, or when you
move it from a cold to a warm location, wait for
about three hours before operating the unit.
Caution
Television programmes, films, video tapes and other
materials may be copyrighted. Unauthorized
recording of such material may be contrary to the
provisions of the copyright laws. Also, use of this
recorder with cable television transmission may
require authorization from the cable television
transmitter and/or programme owner.
Compatible colour systems
This VCR is designed to record and play back using
the PAL colour system. Recording of video sources
mark) must
based on other colour systems cannot be guaranteed.
VIDEO Plus+ and PlusCode are registered
trademarks of Gemstar Development Corporation.
The VIDEO Plus+ system is manufactured under
license from Gemstar Development Corporation.
G X (pause) button (34) (70) (71)
H REC z (record) button (38) (55)
(70)
I PROGRAM +/– buttons* (54) (64)
J SYNCHRO REC (Synchronized
Recording) button (56)
H
* The (play) and PROGRAM + buttons
have a tactile dot.
x ao
y
i
continued

Index to parts and controls

http://www.xiaoyu163.com
8

Getting Started

Index to parts and controls
Refer to the pages indicated in parentheses ( ) for details.
Front panel
For SLV-SE840G
A ?/1 (on/standby) switch
B Remote sensor (12)
C Tape compartment
D A (eject) button (34)
E H (play) button* (35) (53)/M
(fast-forward)/m (rewind) (35)
(53)/Playback Dial (35) (53)
F x (stop) button (21) (34) (70) (71)
G X (pause) button (34) (45) (70) (71)
H REC z (record) button (38) (55)
(70)
I
DIAL TIMER (41)
Q Q
3 6 7 1 3
4 Index to parts and controls
Display window
For SLV-SE840G and SE740G/I
A Tape indicator
B VIDEO indicator (17) (38)
C Time counter/clock/line/programme
position indicator (35) (37) (70)
D
(smartlink) indicator (18)
u163
.
5
1-1
SLV-SE740/SE747/SE840/SX740
2 9 9 4 2 8
This section is extracted from instruction manual.
J AUDIO DUB button (71)
K PROGRAM +/– buttons* (42) (54)
(64)
L SYNCHRO REC (Synchronized
Recording) button (57)
M t LINE-2 L (left) o R (right)
jacks (covered)* (68) (69) (71)
How to open the jack cover
1 Press the bottom of the cover.
2 Hook your finger on the top edge of the
cover and pull it open.
H
* The (play) , PROGRAM + buttons
and jack cover have a tactile dot.
1 5 0 5 8 2 9 9 4
1 2 3
8 7
E TV indicator (40)
F STEREO indicator (60)
G Tape speed indicators (37)
H Timer/recording indicator (38) (43)
(48) (51)
m
co
9 9
2 8 9 9
4 5
6
continued
Index to parts and controls 7