I Outdoor Unit - Daikin FT25CV1A Service Manual

Si01-406

I Outdoor Unit

16
I I I I Indoor Unit
1. Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front grille
5. Grille tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. Display
8. Air outlet
9. Flaps (horizontal blades)
10. Louvers (vertical blades):
• The louvers are inside of the air outlet.
I I I I Outdoor Unit
15. Air inlet: (Back and side)
16. Air outlet
17. Refrigerant piping and inter-unit cable
18. Drain hose
Appearance of the outdoor unit may differ from some models.
System Configuration
15
11. Indoor Unit ON/OFF switch:
12. OPERATION lamp (green)
13. TIMER lamp (Yellow)
14. Signal receiver:
19. Earth terminal:
20. Outside air temperature sensor:
20
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Temperature
Mode
setting
COOL 22°C
• This switch is useful when the remote controller
is missing.
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
• It is inside of this cover.
• It senses the ambient temperature around the
unit.
Instructions
17
18
19
Air flow rate
AUTO
55