Advertisement
Available languages
Available languages
NOTICE:
For longer periods of use, or on large pieces of work, it is advisable
to
use a suitable
vacuum cleaner. Attach a 1-1/4 in. wet/dry-vacuum
hose to the
dust-exhaust
port. it is advisable
to wear a suitable
dust mask, as there may be
residual airborne
dust particles in the area.
,_
WARNING:
The dust that is produced
while sanding
can be detrimental
to health, flammable,
or explosive.
Suitable safety measures
are required.
Examples:
Some types of dust are known to cause cancer. Always wear a dust
mask, and use the proper dust collection
method: dust box for small volume and
vacuum
connection
for large volume dust collection.
SELECTING
THE RIGHT GRADE OF SANDPAPER
Different grades of sandpaper
can be purchased
from the store where you
purchased
the tool. Available
grades are: Coarse, Medium
and Fine.
Use a coarse grit to sand rough finishes,
medium grit to smooth the work and
fine grit for finish sanding.
It is best to make a trial run on a scrap piece of material to determine
the
optimum
grade of sandpaper
for a particular
job.
SANDING
This sander can be used for most sanding operations
on materials such as wood,
plastic, metal and painted surfaces.
Do not use the sander for wet sanding.
,_, WARNING:
Do not touch the vents after prolonged
use; the gear box could
be very hot.
_,
WARNING:
Wear safety goggles,
dust mask, and hearing protection.
_1_ CAUTION:
Clamp the workpiece
to prevent it from moving during operating.
An unsecured
workpiece
could be thrown towards
the operator,
causing
injury.
1.
Plug the sander to the power source.
WARNING:
Before connecting
the sander to power source, always check to
be sure that the switch is in the OFF (O) position.
Failure to do so could result in
accidental
starting
of the sander, causing
possible
serious injury.
2.
Place the sander on the workpiece
so that the sandpaper
is fully in contact
with the workpiece.
3.
Start the sander.
,_
WARNING:
Keep your head away from the sander and the sanding area.
Your hair could be drawn into the sander causing
serious injury.
4.
For best sanding
results, apply light pressure on the sander, but do not
force the tool. Check to make sure that the red pressure control indicator
light never illuminates.
15
Advertisement
