Maintenance; Adjusting The Cutting Angle - Makita LS1040 Instruction Manual

1. Stopper pin

MAINTENANCE

1
1. Hex bolt
16
Carrying tool
001792
Make sure that the tool is unplugged. Secure the blade at 0° bevel angle and
the turn base at right miter angle fully. Lower the handle fully and lock it in the
lowered position by pushing in the stopper pin.
1
Carry the tool by carrying grip as shown in the figure. If you remove the hold-
001774
ers, dust bag, etc., you can carry the tool more easily.
CAUTION:
• Always secure all moving portions before carrying the tool.
• Stopper pin is for carrying and storage purposes only and not for any
cutting operations.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
WARNING:
• Always be sure that the blade is sharp and clean for the best and safest
performance.

Adjusting the cutting angle

This tool is carefully adjusted and aligned at the factory, but rough handling
may have affected the alignment. If your tool is not aligned properly, perform
the following:
1. Miter angle
002258
Loosen the grip which secures the turn base. Turn the turn base so that
the pointer points to 0° on the miter scale. Tighten the grip and loosen
the hex bolts securing the guide fence using the socket wrench.