Download  Print this page

Makita LS1040 Instruction Manual

Compound miter saw
Hide thumbs

Advertisement

Compound Miter Saw
LS1040
DOUBLE
INSULATION

Advertisement

loading

  Related Manuals for Makita LS1040

  Summary of Contents for Makita LS1040

  • Page 1 Compound Miter Saw LS1040 DOUBLE INSULATION...
  • Page 2: Specifications

    The typical weighted root mean square acceleration in accordance with Council Directives, 73/23/EEC, value is not more than 2.5 m/s 89/336/EEC and 98/37/EC. Yasuhiko Kanzaki CE 97 Director MAKITA INTERNATIONAL EUROPE LTD. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND...
  • Page 5 135 mm...
  • Page 7 90 mm 25 mm 90 mm 107 mm 107 mm 90 mm...
  • Page 8: Double Insulation

    Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. Read instruction manual. DOUBLE INSULATION...
  • Page 9: Safety Instructions

    ENGLISH Explanation of general view Base 25 Switch trigger 49 Screw Hex bolt 26 Lever 50 Rod 12 Auxiliary plate 27 Turn base 51 Cutting line 28 Kerf board 52 Groove Bolt 29 Sub-fence 53 Vise Center cover 30 Adjusting bolt 54 Spacer block Socket wrench 31 Pointer...
  • Page 10: Additional Safety Rules

    19. Stay alert 14. Keep hands out of path of saw blade. Avoid con- Watch what you are doing. Use common sense. tact with any coasting blade. It can still cause Do not operate tool when you are tired. severe injury. 20.
  • Page 11 (Fig. 9) as shown in Fig. 17. CAUTION: Use only the Makita socket wrench provided to install or Maintaining maximum cutting capacity remove the blade. Failure to do so may result in overtight- (Fig. 18 & 19) ening or insufficient tightening of the hex bolt.
  • Page 12 Positioning for adjusting the bevel angle Holders and holder assembly (optional accesso- (Fig. 21 & 22) ries) The saw blade tilts up to 45° to the left only when the The holders and the holder assembly can be sub-fence is set to the left position as shown in Fig. 17. installed on either side as a convenient means of To adjust the bevel angle, loosen the lever at the rear of supporting workpieces horizontally.
  • Page 13: Maintenance

    To maintain product safety and reliability, repairs, mainte- When cutting several pieces of stock to the same nance or adjustment should be carried out by a Makita length, ranging from 240 mm to 400 mm, use of the Authorized Service Center.
  • Page 14 ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner.
  • Page 15 • Holder set • Holder assembly • Auxiliary plate • Horizontal vise • Vertical vise...
  • Page 16 Makita Corporation Japan 884085A228...