1
1. Lever
1
2
3
1. Lever
2. Bevel scale
3. Pointer
2
1. Lever
2. Lock-off button
Adjusting the bevel angle
001864
To adjust the bevel angle, loosen the lever at the rear of the tool counterclock-
wise.
Push the handle to the left to tilt the saw blade until the pointer points to the
desired angle on the bevel scale. Then tighten the lever clockwise firmly to
secure the arm.
CAUTION:
•
When tilting the saw blade, be sure to raise the handle fully.
•
After changing the bevel angle, always secure the arm by tightening the
lever clockwise.
001865
Switch action
CAUTION:
•
Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
•
When not using the tool, remove the lock-off button and store it in a
secure place. This prevents unauthorized operation.
•
Do not pull the switch trigger hard without pressing in the lock-off button.
This can cause switch breakage.
For European countries
004853
To prevent the switch trigger from being accidentally pulled, a lock-off button is
1
provided. To start the tool, push the lever to the left, press in the lock-off button
and then pull the switch trigger. Release the switch trigger to stop.
9