Installation And Safety - Telefunken TTV-149 Owner's Manual

Installation and Safety

To ensure safe and reliable operation of the TV set, please observe the following precautions in installation,
operation and maintenance.
Attention:
１·Pay attention to the power supply cord before installing the TV set. Do not hang anything on the cord, and
avoid treading on the cord.
２·The slots on the back housing are designed for ventilation to prevent overheating. They must never be covered
or blocked. The TV set must not be placed near a heat source such as radiator, air ducts direct sunlight.
３·The outdoor antenna must not be erected close to HV lines or other power supply lines. Use extreme care when
erecting the antenna.
4·This TV must be connected to AC 240V 50Hz. Never connect to DC supply or any other power supply
5·Do not let any object fall into the ventilation openings of the TV set housing, nor let any liquid flow into the it
via the openings. This may cause the television to short circuit
6·Do not subject the TV set to rain, or use it in damp environment. In cleaning dust, be sure to remove the power
supply plug from its socket first. Do not clean the television with liquid detergent, use a damp cloth. Be sure to remove
the power supply plug from its socket and remove the antenna plug during a thunderstorm or when it will not be used
for long time, to avoid components being damaged by lightning.
7·If you use an indoor antenna, do not let it touch any electrical appliance, or normal reception of TV program may
be affected.
Safety:
1Never open the rear of the television. High Voltage components can cause fire, electric shock or injury. Qualified
TV service personnel should carry out all internal work.
2. Remove the power supply plug from its socket in case of the following conditions, and consult with service
personnel.
(1) The power cord and plug is damaged or cracked.
(2) Any object has fallen into or liquid flown into the TV set.
(3) The performance of TV set has deteriorated significantly or there is damage on the housing.
(4) The TV set will not operate normally according to the instructions.
3. Please remove the power supply plug from its socket when the TV set will not be used for long time.
The adjusting buttons and some sockets are in the front of the TV, other sockets are in the rear of the TV.
①
Main power switch
②
Remote control sensor
③
Power indicator
④ Program number down (P-) and up (P+)
⑤
Volume decrease (V-) and increase (V+)
⑥
Menu button
⑦
TV/AV button
⑧
AV IN sockets
⑨
Antenna input and AV IN/OUT sockets
TV/ AV M EN U P- P+
7 6 4
V- V+
3 2 1
5