Whirlpool 3369671 Installation Insrtuctions page 12

7. Insert trim piece to cover lower edge of frame. Snap
trim piece into place.
Trim
piece
Lower
frame
8. Press down firmly along the length of the trim piece to
check that trim piece is secure. Slide door panel down.
9. Open and close dishwasher door. Door should close
easily without slamming and open with its own weight.
If door springs need adjusting, close door and move
door spring ends to different holes in dishwasher base.
10. Push up each end of the access panel top trim with
thumbs to unsnap. Remove the top trim and set trim
aside.
3369671-C
11. Hold the top of the color panel(s) and bow slightly. Slide
color panel(s) and spacer panel upward and remove.
Save color panel(s) and spacer panel for future use.
12. Insert wood panel into access panel. Slide panel down
into groove along bottom of access panel.
It may be necessary to remove top mounting screws
and tilt access panel forward to install some wood
panels.
13. Line up ends of top trim with sides of access panel.
Slide top trim in while tilting the back of trim down. Snap
front of top trim down to cover the top edge of access
panel.
If the dishwasher does not start...
Check these points:
• Is the door closed tightly and latched securely?
• Has the cycle been set correctly to start the dishwasher?
• Is the water turned on?
• Has a house fuse blown or circuit breaker tripped?
• Has electrical power been interrupted?
NOTE: If the motor has stopped because of overload, it
will automatically reset itself within a few minutes. If after
checking these points the dishwasher still does not run or
complete a cycle, call for service.
12