Table of Contents
Advertisement
ATTACHING THE CURL PAD
To use the Curl Pad (29), first remove the 50mm
Round Slanted Inner Cap (66) from the Seat Frame
(6). Then, insert the Curl Post (9) into the Seat Frame
and secure the Curl Post with the Curl Knob (64).
Remove the Curl Pad (29) and replace the 50mm
Round Slanted Inner Cap (66) when performing an
exercise that does not require the Curl Pad.
ATTACHING THE CURL BAR
To use the Curl Bar (28), first attach the housing
cables to the leg lever (see ATTACHING THE LEG
LEVER on the previous page). Attach the clip on the
Curl Bar to the hook on the Leg Lever (8).
PLUGGING IN THE RESISTANCE SYSTEM
Plug the indicated end of the Transformer (122) into
the Back Mech Cover (12). Plug the other end of the
Transformer into a 120-volt outlet. All indicators and
displays on the console will flash once; the console
will then be ready for use. The motor may be heard
while the resistance system calibrates itself.
Important: Always plug in the transformer when
using the resistance system.
The resistance system will need to be calibrated man-
ually the first time it is used. To do this, plug in the
Transformer (122) as described above. Then, press
and hold the LBS up and down buttons on the
Console (30) for three seconds. The motor will be
heard while the resistance system calibrates itself.
Follow this procedure whenever the resistance system
does not seem to be working properly and needs to
be recalibrated.
29
9
66
6
28
122
30
14
64
8
12
Press
Hide quick links:
Advertisement
Table of Contents
