Interrupting The Programme; End Of Programme; Terminating The Programme - Bosch SGS 09T06 Instructions For Use Manual

Table of Contents

Advertisement

en

Interrupting the programme

In order to interrupt the programme,
open the door. In order to avoid water
escaping, only open the door slightly
first.
The message "Cancel Programme"
will be displayed, alternating with
the message "Close the door",
the remaining programme time,
the selected programme, and the
current programme phase.
In order to interrupt, do not in any
circumstance press the button –
"Cancel Programme" because this will
not allow the programme to continue!
To continue the programme, close
the door. The programme will continue
automatically.
In the case of a warm water supply or
when the appliance is already heated,
leave the door slightly ajar for a few
minutes before closing it. Otherwise the
door can spring open again due to the
warm air trapped in the device's interior.

Terminating the programme

Open the door. First open the door only
slightly in order to avoid water spraying
out.
The message "Cancel Programme"
will be displayed, alternating with
the message "Close the door",
the remaining programme time,
the selected programme, and the
current programme phase.
In order to cancel the programme,
press –
"Cancel Programme".
3
"To cancel" and "Close the door" are
displayed.
Close the door. The water remaining in
the device's interior will be pumped off.
Once the pumping off has finished
a buzzer will sound 5 times.
Open the door. "End" is briefly
displayed, the appliance automatically
switches off after 5 seconds.
24
Downloaded from DishWasher-Manual.com Manuals

End of programme

As soon as the programme has finished
a buzzer will sound 5 times.
Open the door. "End" is briefly
displayed, the appliance automatically
switches off after 5 seconds.
If the door is not opened, an acoustic
signal sounds every 10 minutes for one
hour.
After letting the device cool down take
out the dishes.
3
For an optimum drying of the dishes wait
for 15 minutes after the programme has
finished before you open the door and
empty the dishwasher. During this time the
possibly remaining water on the dishes
can evaporate and condense on the sides
of the device's interior.
If the device becomes disconnected from
the power supply during operation (e.g.
it is switched off or there is a power cut),
all settings remain stored. Operation
will resume automatically once the power
supply has been restored.
Note
Note

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents