Buzzer Volume; Adding Rinse Aid; Onboard Computer; Water Hardness - Bosch SGS 09T06 Instructions For Use Manual

Saving time (VarioSpeed)
The Auto Programmes allow you to reduce
the run time of the programmes. However,
in order to achieve an optimal cleaning
result, the water and energy consumption
will be increased.
If the option "Reduce time" is chosen
the display shows "Reduce Time: Off"
(factory setting).
Select "Reduce time: On".
Return to the Main Menu by pressing
M/OK and start the required
2
programme by pressing the Start
Button .
4
If you do not want to use "Reduce time"
the next time you use the dishwasher,
you must deselect this option.

Onboard computer

If the "Onboard computer on" option
is activated, the following displays are
indicated in succession according to
the selected programme:
"Normal spray active"/"Gentle spray
active"/"Intensive spray active"
"Hygienic washing"
"Glass protection system is active"
"Heat exchanger is active".
If the onboard computer option
is selected,
"Onboard computer off" is displayed
(factory setting).
Select "Onboard computer on".
If you no longer wish additional
information to be displayed during
the next rinse cycle, you must
switch the option off again.
Drying Level
If the option "Drying Level" is chosen
the display shows "Normal drying"
(factory setting).
Alternatively you can select "Eco drying"
or "Extra drying".
The option "Extra drying" increases
the temperature during rinsing in all
programmes. (Please take care with
delicate dishes.)
Downloaded from DishWasher-Manual.com Manuals

Buzzer Volume

You can vary or even completely switch
off the volume of the acoustic
end-of-programme signal.
If the option "Buzzer Volume" is chosen
the display shows "Buzzer 6" (factory
setting).
You can change this value to 0
(acoustic signals switched off) or
to values between 1 (quiet) and
6 (loud). A short buzz demonstrates
the currently chosen volume level.

Adding Rinse Aid

You can set the amount of rinse aid
added.
If the option "Adding Rinse aid" is
chosen the display shows "Rinse Aid 4"
(factory setting).
Change this setting only if there are
streaks (reduce the value) or water
stains (increase the value) remaining
on the dishes.
You can choose a value between 0
and 6.

Water Hardness

Before starting the appliance for the first
time or in case of changes in the water
hardness, the dishwasher's softening
system must be set to the hardness of
your mains water supply. Follow the
instructions set out in the chapter "Set-up
of the Softening System".
Interior light *
20
If the interior light option is selected,
"Interior light: On" is indicated on the
display (factory setting). You can switch
the interior light on or off. The avtivated
interior light comes on when the door is
open, irrespective of whether the main
switch is on or off. When the door is
closed or ajar, the light is off.
* some models
en
21