Serve@Home - Bosch SGS 09T06 Instructions For Use Manual

Switching "Refill salt" and
therefore the water softening
system off and on:
Switch on the appliance with the main
switch .
1
Keep pressing button M/OK
the "Hardness" setting is displayed.
By pressing buttons – or +
a set value between 0 (off) and 7.
The factory setting is "Hardness 4".
Switch off by selecting the set value "0"
Press the button M/OK
value is saved and you are returned
to the Start menu.
If the setting is "0" (off) the softening
system is switched off. Possible lack of
salt will not be indicated.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.
Downloaded from DishWasher-Manual.com Manuals
* on applicable models
This dishwasher is serve@Home capable.
serve@Home is a network comprising
other serve@Home domestic appliances
besides dishwashers. Through it the
until
2
device offers you greater comfort and
mobility, at home as well as on the road.
, select
3
In order for your dishwasher to become
serve@Home capable, you will need a
special accessory, the System Interface.
You can purchase this interface from your
The set
2
specialist supplier. The interface must be
mounted in the chamber at the front of the
dishwasher following the installation
instructions supplied with the system
interface.
When you select your dishwasher's mode
"Remote Control: On" you can remotely
control the device.
You can set up and start the prepared,
switched on, and closed dishwasher if you
are not at home. Equally, you can switch
off your dishwasher at any time, even if the
device is not in the Remote Control Mode.

serve@Home *

en
17