Advertisement
Available languages
Available languages
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide resonable protection against radio frequency interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception (this can be determined by turning this equipment off and on), the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between this equipment and the receiver.
•
Connect this equipment to an outlet on a circuit different from which the receiver is connected to.
•
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet, prepared by the Federal Communications Commission,
helpful: "How to Identify and Resolve Radio-TV Interference Problems". This booklet is available from the U.S.
Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
Caution:
To comply with the limits for an FCC Class B computing device, always use the AC adapter, the shielded signal
cord and power cord supplied with this unit.
Caution to the user
The Federal Communications Commission warns the user that changes or modifications to the unit not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.
DOC Compliance Notice
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out
in the Radio Interference Regulations of the Canadian Department of Communications.
DOC Avis de Conformation
Le présent appareil numérique n'emet pas de bruits radioélectriques dépassant les limites applicable aux appareils
numériques de la classe B prescrites dans le Réglement sur le brouillage radioélectriques édicté par le ministére
des Communications du Canada.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
U.S.Responsible Party: NEC-Mitsubishi Electronics Display of America, Inc.
Address:
Tel.No.:
Windows is a registered trademark of Microsoft Corporation. NEC is a registered trademark of NEC Corporation.
All other brands and product names are trademarks or registered trademarks of their respective owners.
E
S
is a U.S. trademark.
NERGY
TAR
As an E
S
Partner, NEC-Mitsubishi Electronics Display of America, Inc. has determined that this
®
NERGY
TAR
product meets the E
NERGY
EPA endorsement of any product or service.
Notice of Compliance Canadian
Interference-causing Equipment Regulations
DECLARATION OF CONFORMITY
1250 North Arlington Heights Road, Suite 500
Itasca, Illinois 60143-1248
(630)467-3000
Type of Product:
Equipment Classification:
Model:
We hereby declare that the equipment specified above
conforms to the technical standards as specified in the FCC Rules.
S
guidelines for energy efficiency. The E
TAR
Computer Monitor
Class B Peripheral
MultiSync LCD1700V
NERGY
MultiSync LCD1700V 3
S
emblem does not represent
TAR
Advertisement
Chapters
