1 General
The Electrical Installation Instructions describes the procedures for installing all of the
hardware and software needed to perform testing, calibration, and repair activities at an
Electrical level for the Sony Ericsson products specified.
2 Go/No Go Testing
There are two options for performing a Go No/Go test. One is to use an RF Fixture and
the other is to use an antenna coupler together with a shielding box.
2.1 Test Set-Up Go/No Go test
All test hardware necessary for this test set up is documented in the Mechanical or
Electrical Equipment Lists.
T est S et
RF Cable
RF S hield Box
1206-4804 Rev1
©
Company Internal
Sony Ericsson Mobile Communications AB
Printer
OPT IONAL
GPIB Cable
RF Probe
Holder
RF
Probe
OPT IONAL
Installation Instruction, Electrical
OPT IONAL
2(16)