Installing A Brooktrout Fax Board - GFI FAXMAKER Installation Manual

check passes you can continue with installation of GFI FaxMaker. An unsuccessful line check will
return an error code which can be referenced on the Dialogic technical support website for the cause
and a list of possible solutions.
NOTE
You can use the Dialogic Diva Server Configuration Manager utility to setup advanced
configurations such as sharing the Dialogic Adapter between GFI FaxMaker and Routing and
Remote Access for dial-up access. For further information on this consult the Dialogic
documentation.

1.3 Installing a Brooktrout Fax Board

The list of currently supported Brooktrout cards is available from
BrooktroutCards. Installation guides, product documentation and support are available from the
Dialogic Technology website at http://www.dialogic.com/default.htm.
NOTES
1. The current Brooktrout boards are Universal PCI (3.3/5 volts); however always check the
technical details of the adapter to make sure it is suitable for the server hardware.
2. You must always install GFI FaxMaker software before installing Brooktrout or Trufax drivers.
3. Ensure that the correct Brooktrout card driver is installed. For more information on Brooktrout
drivers refer to http://go.gfi.com/?pageid=FM_BrooktroutDrivers.
1.3.1 Brooktrout TR1034, Trufax ISDN cards or Trufax Analog cards
To install Brooktrout fax cards:
1. Switch off the computer where you want to install the Brooktrout Fax card. Plug in the card
following the instructions supplied with the hardware.
2. Restart the computer. Ignore any Add New Hardware wizard dialog by pressing Cancel.
3. Navigate to <GFI installation folder>\brooktrout\.
4. Double click the executable file brooktrout_tr1034.exe.
5. In the Welcome dialog, click Next. Read and accept the End User License Agreement dialog and
click Next to continue installation.
6. Set to the path where GFI FaxMaker is installed. If require changing the default installation path,
clicking Browse and specify the required path; else continue with the installation, by clicking Next.
7. Click Install to install drivers and click Finish to finalize driver installation.
NOTE
If the installation has detected existing Brooktrout drivers on the computer, you are asked to
reboot your computer. This is required just in case the mentioned drivers where being used (i.e.
were locked) and could not be replaced with the newly installed drivers.
GFI FaxMaker
http://go.gfi.com/?pageid=FM_
1 Installing fax devices
|
6