Installing The Brooktrout Sr140 (Foip) - GFI FAXMAKER Installation Manual

1.4 Installing the Brooktrout SR140 (FoIP)

The Brooktrout SR140 is a software-only Fax over IP (FoIP) solution from Dialogic Technology. To
install the Brooktrout SR140 follow these steps:
1. Click on Start > GFI FaxMaker > FaxMaker Configuration Wizard.
2. In the Welcome page, click Next to continue. The wizard will stop the GFI FaxMaker Fax Server
Service and the GFI FaxMaker Message Transfer Agent Service. Click Next to continue once the
services are both stopped.
Screenshot 9: Selecting the Brooktrout SR140 driver
3. Click on Brooktrout by Dialogic and select Brooktrout SR140 Software Fax over IP. Click Next to
continue.
4. The wizard will ask you whether you want to run the FaxMaker Brooktrout TR1034 (Boston) /
SR140 driver setup. Click YES to start the driver setup wizard.
NOTE
The Brooktrout TR1034 (Boston) / SR140 driver setup contains drivers that are made by Dialogic
Technology, however Dialogic Technology relies on vendors to distribute them.
5. Setup will start by checking if there is any Brooktrout software already installed on the machine.
Should it be the case, uninstall any existing Brooktrout software using the Add/remove programs
from the Control Panel. After all Brooktrout software has been uninstalled, restart the Brooktrout
setup again.
6. In the setup wizard Welcome page, click Next to continue. Read and accept the End User License
Agreement and click Next to continue the installation.
7. At this stage, you can specify the location where you want to install the TR1034 drivers. By
default, the installation path is set to the same path where GFI FaxMaker is installed. We recommend
GFI FaxMaker |
1 Installing fax devices 10