NordicTrack 831.298650 User Manual page 6

3. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an M8 x 19mm Screw (30). Tighten the Screw
into one end of an Incline Axle (29). Next, apply a
small amount of the included grease to the Incline Axle.
Align the indicated tubes on the Incline Ramp (5) with
the tubes on the Frame (1). Make sure that the
Incline Ramp is turned so the V-shaped grooves
are on top. Insert the Incline Axle (29) into the Incline
Ramp and the Frame. Note: It may be helpful to tap
the Incline Axle with a rubber mallet to insert it.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto another M8 x 19mm Screw (30). Tighten the
Screw into the open end of the Incline Axle (29).
4. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an M8 x 19mm Screw (30). Tighten the Screw
into one end of the other Incline Axle (29). Next, apply
a small amount of grease to the Incline Axle.
Raise the Incline Ramp (5). Insert the Incline Axle (29)
through one side of the Incline Ramp, through a 56mm
Spacer (24), through the end of the motor screw,
through another 56mm Spacer (24), and then through
the other side of the Incline Ramp.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto another M8 x 19mm Screw (30). Tighten the
Screw into the open end of the Incline Axle (29).
5. While another person holds the Upright (2) near the
Frame (1), connect the Wire Harness (85) to the
Extension Wire Harness (51). Next, attach the Upright
to the Frame with three M10 x 25mm Screws (102)
and three M10 Split Washers (22). Be careful to
avoid pinching the wire harnesses.
3
5
Grease
58
33
30
4
5
Grease
58
29
33
30
5
Make sure the
Wire Harnesses
(51, 85) do not
get pinched and
damaged during
this step.
6
V-shaped Groove
58
33
Tubes
Tubes
29
1
Motor
Screw
58
33
24
2
22
102
102
22
51
22
85
1
30
30