Replacing The Light Bulb; Cleaning The Oven Door - Hotpoint FH 89 P IX/HA S Operating Instructions Manual

• All accessories - with the exception of the sliding racks
GB
- can be washed like everyday crockery, and are even
dishwasher safe.
• We recommend that detergents are not sprayed directly
onto the control panel, but that a sponge is used instead.
! Never use steam cleaners or pressure cleaners on the
appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with a
soft cloth. Do not use rough abrasive material or sharp metal
scrapers as these could scratch the surface and cause the
glass to crack. For more thorough cleaning purposes, the
oven door may be removed:
2. Lift up and turn the small levers located on the two hinges
(see diagram);
F
To replace the door, reverse this sequence.
26
1. Open the oven door fully (see
diagram);
F
With glass panel fitted to
the inside of the door
3. Grip the door on the two external
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
3. (With glass panel fitted to the
inside of the door) Grip the door on
the two external sides and close it
approximately half way. Unlock the
door by pressing on the clamps F,
then pull the door towards you lifting
it out of its seat (see diagram).
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal (only on a
few models)
Glass door
! Do not use the oven lamp as/for ambient lighting.
Automatic cleaning with the FAST CLEAN
function
With the FAST CLEAN mode, the internal temperature of
the oven reaches 500°C. The pyrolytic cycle is activated,
burning away food and grime residues. Dirt is literally
incinerated.
Keep children away from the appliance during the automatic
cleaning cycle as surfaces may become very hot. Particles
may ignite inside the oven due to the combustion process.
There is no cause for concern: this process is both normal
and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of
the oven using a damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where
present);
• Do not place tea towels or pot holders over the oven
handle.
• Turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start. Wait
for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the FAST CLEAN cycle press and hold the
button for approximately 4 seconds. The TIMER KNOB may
be used to select the desired cleaning level; there are three
default time settings which cannot be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1
hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2
hours.
4. Press the button to confirm.
To replace the oven light bulb:
1. Remove the glass cover
using a screwdriver.
2. Unscrew the light bulb
and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover,
making sure the seal is
positioned correctly (see
diagram).