Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell E2010H User Manual

Back to Contents Page

Setting Up the Monitor

Dell™ E2010H/E2210H/E2310H Flat Panel Monitor User's Guide
Attaching the Stand
Connecting Your Monitor
Attaching the Dell Soundbar (Optional)
Removing the Stand Base
Wall mounting (Optional)

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.
Remove the monitor cover and place the monitor on it.
1. Fit two tabs on the upper part of the stand to the groove on the back of the monitor.
2. Lower the monitor so that the monitor mounting area snaps onto the stand.

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not connect both cables on the same computer. Use both the cables only when they are connected to two different computers with
appropriate video systems
Connecting the VGA Cable
Connecting the DVI Cable
Downloaded from ManualMonitor.com Manuals
Safety Instructions.