Remote Control Handling; Replacing The Batteries; Operation Failure With The Remote Control; Temporary Run Operation - Mitsubishi Electric SRK25ZJP-S User Manual

Remote control handling

Replacing the batteries

The following cases signify exhausted batteries. Replace old batteries with new ones.
• Receiving beep is not emitted when a signal is transmitted.
• Display fades away.
1
Pull out the cover and take out
old batteries.
2
Insert new batteries.
R03 (AAA, Micro) x2
3
Close the cover.
4
Press the ACL switch with the
tip of a ballpoint pen.
The timer setting mode is displayed.
Page 7
Warning note for remote control handling
• Do not go near high temperature
places, such as an electric carpet
or stove.
• Do not put any obstructing obsta-
cles between the remote control
and the unit.

Operation failure with the remote control

• Are the batteries running down?
"Replacing the batteries" above.
Replace the batteries with new ones and retry the operation.

Temporary run operation

• The unit ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE :
• FAN SPEED
• AIR FLOW
• Operation starts by pressing the unit ON/OFF button; it stops if you press
the button again.
NOTE
• Do not hold the Unit ON/OFF button down for more than 5 seconds.
(Holding it down longer than 5 seconds sets the automatic cooling used during servicing or when relocating the air-conditioner.)
• Do not use old and new batteries together.
• Remove the batteries when the remote control is not used for a long period.
• The recommended effective period of a battery conforming to JIS or IEC should be
6 to 12 months with normal use. If used longer, or when an unspecified battery is
used, liquid may leak from the battery, causing the remote control to malfunction.
Pay attention to
• The recommendable effective period is printed on the battery. This may be shorter
the ª and ·
due to manufacturering time to the unit. However, the battery may still be in
marks
working order after expiry of its nominal life.
■ When the display shows any abnormal condition, Press the ACL switch with
the tip of a ballpoint pen.
Using the remote control holder
The remote control can be attached to a wall or pillar by
using a remote control holder. Before installing the remote
control, check that the air-conditioner receives the signals
properly.
For installing or removing the remote control, move it up or
down in the holder.
Strictly prohibited
• Do not leave the remote control ex-
posed to direct sunlight or other
strong lighting.
• Do not spill any liquid on the
remote control.
AUTO
: AUTO
: AUTO
NOTE
• If the operation fails, operate the unit with
temporary operation function.
Contact your dealer to have the remote control
checked.
– 6 –
• Do not drop the remote control.
Handle with care.
• Do not place heavy objects on the
remote control, or step on it.
Unit ON/OFF button
Below