Remote Control Handling; Replacing The Batteries; Operation Failure With The Remote Control; Temporary Run Operation - Mitsubishi Electric SRF25ZIX-S User Manual

Remote control handling

Replacing the batteries

1
Pull out the cover and take out
old batteries.
2
Insert new batteries.
R03 (AAA, Micro) x2
Pay attention to
the ª and ·
marks
3
Close the cover.
4
Press the ACL switch with the
tip of a ballpoint pen.
The timer setting mode is displayed.
Page 7
Warning note for remote control handling
• Do not go near high temperature
places, such as an electric carpet
or stove.
• Do not put any obstructing obsta-
cles between the remote control
and the unit.

Operation failure with the remote control

• Are the batteries running down?
"Replacing the batteries" above.
Replace the batteries with new ones and retry the operation.

Temporary run operation

• The unit ON/OFF button on the unit operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE :
• FAN SPEED
• AIR FLOW
• Operation starts by pressing the unit ON/OFF button; it stops if you press
the button again.
NOTE
• Do not hold the Unit ON/OFF button down for more than 5 seconds.
(Holding it down longer than 5 seconds sets the automatic cooling used during servicing or when relocating the air-conditioner.)
The following cases signify exhausted batteries. Replace old batteries with new ones.
Receiving beep is not emitted when a signal is transmitted.
•
• Display fades away.
NOTE
• Do not use old and new batteries together.
• Remove the batteries when the remote control is not used for a long period.
• The recommended effective period of a battery conforming to JIS or IEC should be
6 to 12 months with normal use. If used longer, or when an unspecified battery is
used, liquid may leak from the battery, causing the remote control to malfunction.
• The recommendable effective period is printed on the battery. This may be shorter
due to manufacturering time to the unit. However, the battery may still be in
working order after expiry of its nominal life.
■ When the display shows any abnormal condition, Press the ACL switch with
the tip of a ballpoint pen.
Using the remote control holder
The remote control can be attached to a wall or pillar by
using a remote control holder. Before installing the remote
control, check that the air-conditioner receives the signals
properly.
For installing or removing the remote control, move it up or
down in the holder.
Strictly prohibited
• Do not leave the remote control ex-
posed to direct sunlight or other
strong lighting.
• Do not spill any liquid on the
remote control.
AUTO
: AUTO
: AUTO
• If the operation fails, operate the unit with
temporary operation function.
Contact your dealer to have the remote control
checked.
– 6 –
• Do not drop the remote control.
Handle with care.
• Do not place heavy objects on the
remote control, or step on it.
Unit ON/OFF button
Below