Nokia 702 User Manual page 105

Tip: To change the settings for call diverting,
press , and select
divert. See "Call diverting" on page 113.
Replace intl. prefix—If you have a specific international call
prefix number when making an international call from
Japan, select Yes and enter the international call prefix
number. If you save a phone number starting with + mark
and the country code is not 81 (81 is Japan's country code)
in Contacts and you make a call to that number, + mark
will be replaced with the prefix number you saved. Select
No when making a call from a country where the saved
prefix number is not in use. This setting is valid only for
normal voice, video, data, and fax calls depending on
roaming agreements between operators.
Automatic redial—Select On, and your phone makes a
maximum of ten attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dial—Select On, and the numbers assigned to the
speed dialling keys (
pressing and holding the key. See also "Speed dial a phone
number" on page 30.
Tools > Settings > Call
— ) can be dialled by
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any key, except
, , and .
Reject a call as follows when the anykey answer is set to
On.
• Reject a call with SMS when a call comes in (see page
104. To use , press
of Silence > Send msg.
• To reject a call when a call comes in, press
when a call comes in.
Line in use (network service)—This setting is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip: To switch between the phone lines, press
and hold in the standby mode.
Line change (network service)—To prevent line selection,
select Line change > Disable
To change this setting, you need the PIN2 code.
,
(Right selection key) in order
(End key)
if supported by your SIM card.
105