Reinstall; System Information; Conditional Access - Nokia Mediamaster 9660S Owner's Manual

Reinstall

This will start the Installation procedure from the "Welcome
Menu".
When you press OK in the "Welcome Menu" again,
be aware of the fact, that all previous channels and settings
will be erased! To exit the "Reinstall" menu without erasing
any channels, press "Back".

System Information

This gives general information about which hardware
and software version your Mediamaster is running on.

CONDITIONAL ACCESS

This menu will only be activated if you have inserted a valid
Smartcard in the slot behind the front lid.
From here you will get access to information and menus
connected to the Common Interface(CA) Module.
This information may vary a lot depending on the Service
Provider.
If more than one CA system is activated, select the one from
which you want information.
Please see the documentations delivered together with your CA
Module.
About Home Transponder
Home Transponder function refers to the Receiver default setting on a home frequency when a code
is activated on standby mode. Here, once an access card is detected on its slots, This receiver
automatically becomes active and sets to the three Home Frequencies which are as follows;
NILESAT: Showtime Package (11996MHz, Horizontal, 27500Msymbols, FEC=3/4)
ARABSAT: ART & PEHLA package (12604MHz, Horizontal, 27500Msymbols, FEC=3/4)
HOTBIRD: ABSAT package (11681MHz, Horizontal, 27500Msymbols, FEC=3/4)
The STB continuously receives signal even in standby mode so access card automatically becomes
active once a new code is sent by the service provider.
GB 26