Table of Contents
Advertisement
Warning : Always place the battery on a heat resistant surface and never leave it unattended!
Remote Control / Transmitter
Copyright WLtoys.eu | DroneX BV
1. Charging wire
2. LED
3. Li-po Battery
Plug the charger into a wall socket and connect the battery to
the charger. This can only be done in one way: by firmly
connecting the charging cable. If the green light is on, the
battery is fully charged and can be disconnected. Then do not
forget to unplug the charger from the wall socket.
Green LED = Charged battery
Orange LED = Charging battery
Red LED = Battery is empty / Charging battery
Input : 220V
Charging Current : 500mA
Full Voltage: 4.2 +/- 0.03V
1.
Power LED
2.
4 speeds control
3.
Gear lever
4.
Throttle trim
5.
Rotation trim
6.
LCD display
7.
Antenna
8.
Power switch
9.
Mode 1 or 3 / Mode 2 or 4 switch (hardware)
10.
360 degree Roll
11.
Directional lever
12.
Forwards and backwards trim
13.
Crab trim
14.
Module 1 : Water jet; bubble jet; video; basket up; lead
single missile
15.
Lighting control
16.
Module 2 : Taking photos, running missiles, basket down
17.
Mode 1 or 3 / Mode 2 or 4 switch (software)
Advertisement
Table of Contents
