Advertisement
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- To open the appliance, first remove the filter cover
(item 33).
- Then remove the hinge;
first remove the end caps
(item 17) this can be done
with a screwdriver, see
picture.
When the end caps are removed, the hinging pin can be
removed and the hinge can be taken off the appliance.
- Remove the can with the filters.
- Now remove the drive coupling (item 13) by turning it
clockwise.
- To remove the housing (10 screws), for some screws you
will require a screwdriver with 14.5 cm long shrank.
Screwdriver 4322 009 08490 for T15 can be used.
- When the repair is finished, check whether all functions of
the appliance work properly.
- To disassemble the cord winder, use TORX screwdriver no.
T10, which is one of a set consisting of T20; T15; T10; T9;
T8; T7 and T6 (code number 4822 395 50145)
ELECTRICAL DIAGRAM
MOTOR
POWER
MODULE
Further disassembly advise for the hinge:
- First remove the 2 screws (A) underneath the handle to
remove the hinge back (item 2)
- The user panel can be removed after removing the screw (B)
in the middle of the hinge on the inside.
- PCB can be removed.
- Choke valve can be taken out.
- To remove the sealing disk and the detector with the spring
you have to remove the 2 screws (C) next to the sealing
disk.
REPAIR INSTRUCTION
- Due to precisely pre-adjusted belt-tension, rattle drive unit
(item 27) may only be replaced as a complete unit.
Do not disassemble this unit in any way!
- The cord winder spring must be tensioned to the maximum
level and the be rewound approx 1.5 turn.
- Item 9, air valve, opens to cool the motor if the air
displacement is too low or if the airflow is blocked.
Black
M
Blue
Blue
Black
Black
Red
Red
Brown
Brown
FC9222/02
CORD
WINDER
Brown
M
RATTLE
DRIVE
MOTOR
2-7
Advertisement
