Sanyo VPC-HD1AEX Instruction Manual page 170

3
Select "PictBridge", and press the
SET button.
4
The PictBridge printing mode is
activated.
h The camera switches to the
PictBridge printing mode, and the
PictBridge Screen appears.
CAUTION
Insert and pull out the cable carefully
i When connecting the cables, make sure that the cable plugs are correctly
oriented and that they match the shapes of the terminal sockets on the
devices. Push the plugs in straight when connecting them. If undue force is
used to connect a cable, it may permanently damage the connector pins in
the terminal socket.
i Do not use excessive force when connecting and disconnecting cables.
Caution when connecting a printer
i If the power to the printer is turned off while it is connected, the camera
may not operate correctly. If the camera does not operate correctly,
disconnect the USB interface cable, turn off the camera, and then
reconnect the cable.
i During PictBridge printing, the camera's button operation response is
slower.
i If the camera is powered by the battery pack for printing, make sure that
the remaining battery charge is sufficient.
Downloaded From VideoCamera-Manual.com Manuals
PRINTING MODE
PRINT 1 IMAGE
Print this image
English
156