Makita UM164D Instruction Manual page 15

4
1. Crank
2. Apply grease.
3. Pins
4. Recessed part of crank
010906
Fit the crank with its recessed part facing downward onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
1. Oval holes that are overlapped
2. Hole in the base plate of shear blades
3. Base plate
010907
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
1
010908
Take out the blade cover from the old shear blades and fit
it onto the new ones for easy handling during the
replacement of blades.
1
2
3
3
1
2
1. Blade cover
1
010909
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the base
plate of the shear blades is set in place.
1
010910
Tighten two screws with a coin or similars firmly.
1
2
010911
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
010912
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
15
1. Bent part of the
base plate of
shear blades
1. Screws
1. Locking lever
2. Undercover
on the
on the locking
on