Appendix; Troubleshooting - PURE Highway 400 Manual

Resetting Highway to factory settings
Resetting Highway removes any stored presets, clears the station list and resets all options to defaults.
1. Press the button.
2. Turn and press the Select dial to choose 'SETTINGS' > 'RESET'.
3. To reset Highway, turn and press the Select dial to choose 'YES' or choose 'NO' if you don't want to reset Highway.
Wait for Highway to reset.
Note: If you can't access the 'RESET' menu, you can reset Highway using the Reset button on Highway's receiver. See the
'Troubleshooting' section of this user guide.

Appendix

Troubleshooting

I can't reset Highway to factory settings from my wireless controller
If you can't access the 'RESET' menu on your wireless controller, you can reset Highway using the Reset button on Highway's receiver.
Note: You will need to use a paperclip or pen to reset Highway to factory settings.
To reset Highway to factory settings:
1. Remove and re-insert the Highway power adapter into the 12V accessory socket.
2. Within 5 seconds, while the Status LED on Highway's receiver is lit solidly, use a paperclip or pen to press the Reset button.
The Status LED will flash rapidly three times to indicate that the factory reset has started.
My wireless controller displays a 'Receiver connecting' message
Check the power supply to the receiver is properly inserted into your vehicle's power socket.
Check that Highway is not in USB upgrade mode.
Power cycle your receiver by removing and re-inserting the USB Highway power adapter.
The Status LED on Highway's receiver is constantly illuminated
If the Status LED on Highway's receiver is constantly illuminated, it means that Highway is expecting a software update via the USB
connection. If this is unintentional, you can exit USB update mode by removing the power or by holding down the Reset button for
10 seconds.
EN
23